Nitrogen evolution during the co-combustion of hydrothermally treated municipal solid waste and coal in a bubbling fluidized bed

Nitrogen evolution was studied during the co-combustion of hydrothermally treated municipal solid wastes (HT MSW) and coal in a bubbling fluidized bed (BFB). HT MSW blending ratios as 10%, 20% and 30% (wt.%) were selected and tested at 700, 800, 900 °C. Emissions of NO and N₂O from blends were measured and compared with the results of mono-combustion trials. Moreover, concentrations of precursors like NH₃ and HCN were also quantified. The results are summarized as follows: NO emissions were predominant in all the cases, which rose with increasing temperature. The blending of HT MSW contributed to the NO reduction. N₂O emissions decreased with temperature rising and the blending of HT MSW also presented positive effects. At 30% HT MSW addition, both NO and N₂O emissions showed the lowest values (391.85 ppm and 55.33 ppm, respectively at 900 °C). For the precursors, more HCN was detected than NH₃ and both played important roles on the gas side nitrogen evolution.     

臭氧氧化—包埋菌流化床生物处理组合工艺深度处理煤气化废水

采用臭氧氧化—包埋菌流化床生物处理组合工艺对煤气化废水进行深度处理。实验结果表明：当臭氧的质量浓度20 mg/L、臭氧进气流量1.5 L/min、臭氧通气时间30 min、包埋菌流化床水力停留时间24 h时，臭氧氧化工序的COD去除率达到30.0%~40.0%，总酚去除率达到100.0%；包埋菌流化床工序的COD去除率达到60.0%以上，氨氮的去除率大于95.0%；经组合工艺处理后，出水COD<60 mg/L，ρ（氨氮）<1.0 mg/L，ρ（总酚）未检出，色度小于50倍，达到GB8978—1996《污水综合排放标准》中的一级排放标准。     

循环流化床锅炉掺烧高炉煤气的应用

介绍了高炉煤气的主要燃烧特性，分析了高炉煤气在循环流化床锅炉中掺烧时对炉膛换热、过热蒸汽温度、锅炉负荷、热效率、分离装置以及环境的影响，并提出了消除不良影响的相应措施。     

燃煤电厂产生和排放的PM2.5中水溶性离子特征

为了认识我国燃煤电厂一次PM2.5排放特征,并定量评估大规模开展烟气脱硫与脱硝对其影响,本研究选取了国内一个煤粉炉电厂和一个循环流化床电厂,对其产生和排放的PM2.5进行现场测试,并进行水溶性离子组分的分析.结果表明,在所测的这两个电厂中,循环流化床电厂产生的PM2.5的质量浓度高于煤粉炉电厂产生的PM2.5的质量浓度,但是这两个电厂排放的PM2.5的质量浓度相当.产生此结果的主要原因是该循环流化床电厂配备的电袋复合除尘器比煤粉炉电厂的普通电除尘器对PM2.5去除效率更高.煤粉炉电厂产生PM2.5中水溶性离子浓度低于循环流化床电厂,但是煤粉炉电厂排放PM2.5中水溶性离子浓度却远远高于循环流化床电厂,表明煤粉炉电厂排放的PM2.5受脱硫和脱硝设施的影响较大.煤粉炉烟气脱硝过程中可能形成硫酸雾,烟气中的部分硫酸雾和过剩的NH3反应生成NH4HSO4进入颗粒相,同时降低了PM2.5的p H值;而脱硫过程中脱硫液的夹带也会导致NH+4和SO2-4进入PM2.5.所以,虽然两个电厂产生的PM2.5中水溶性离子均以Ca2+和SO2-4为主,但煤粉炉排放PM2.5中的水溶性离子则以NH+4和SO2-4为主.     

Amoxicillin effects on functional microbial community and spread of antibiotic resistance genes in amoxicillin manufacture wastewater treatment system

This study aimed to reveal how amoxicillin(AMX) affected the microbial community and the spread mechanism of antibiotic resistance genes(ARGs) in the AMX manufacture wastewater treatment system. For this purpose, a 1.47 L expanded granular sludge bed(EGSB) reactor was designed and run for 241 days treating artificial AMX manufacture wastewater. 454 pyrosequencing was applied to analyze functional microorganisms in the system. The antibiotic genes OXA_(-1), OXA_(-2), OXA_(-10), TEM_(-1), CTX-M_(-1), class I integrons(intI1) and 16 SrRNA genes were also examined in sludge samples. The results showed that the genera Ignavibacterium, Phocoenobacter,Spirochaeta, Aminobacterium and Cloacibacillus contributed to the degradation of different organic compounds(such as various sugars and amines). And the relative quantification of eachβ-lactam resistance gene in the study was changed with the increasing of AMX concentration.Furthermore the vertical gene transfer was the main driver for the spread of ARGs rather than horizontal transfer pathways in the system.     

反硝化脱硫工艺中微生物群落结构及动态分析

为了研究反硝化脱硫工艺(denitrifying sulfide removal,DSR)中微生物群落与工艺运行的相关性,实验提取了反应器运行不同阶段污泥样品中微生物的全基因组DNA,利用高通量宏基因组学技术———基因芯片来解析各阶段功能微生物群落的结构特征及其演替过程.通过对功能基因的Simpson、Shannon多样性指数和聚类分析表明,微生物群落结构会随着反应器运行的阶段进行相应调整,且变化较大.在运行的前两个阶段,由于不适应环境,微生物群落的多样性指数比起始时明显减少,随着反应器的运行污泥逐渐成熟,多样性指数迅速增加,也标志着反应器进入稳定运行阶段.通过对反硝化脱硫过程中关键基因相对丰度的分析发现,功能基因的丰度不仅能反映功能菌群的活性,而且与工艺处理效果密切相关.     

流化床O2/CO2气氛下添加SiO2对燃煤PM2.5的控制

采用小型流化床研究了在O2/CO2气氛下添加SiO2对PM2.5(空气动力学直径小于2.5 μm的颗粒物)的控制,试验在1123 K、O2/CO2气氛下进行,并采用荷电低压撞击器(ELPI)采集和分析燃烧后的PM2.5.结果表明,添加SiO2是燃烧过程中影响PM2.5生成的重要因素.添加SiO2后,生成PM1的质量浓度均降低,而PM1-2.5的质量浓度均略有增加;PM2.5质量粒径分布均呈双峰分布,峰值分别出现在0.2 μm和2.0μm左右.随着SiO2添加量的增加,PM2.5中的S、K、Na、Cu和Pb元素的含量呈减少的趋势;随着颗粒粒径减小,S、K、Na、Cu和Pb元素的含量有增高的趋势.     

流化床焚烧含盐苯胺废液的NOx排放特性

在流化床焚烧实验装置上进行含盐苯胺(C6H5NH2)废液的焚烧实验研究,用IMR-IMR2800P废气分析仪对焚烧尾气成分进行了在线监测,考察了焚烧工艺条件对NOx排放浓度的影响规律.结果显示:采用分级燃烧工艺和提高焚烧温度,可以降低NOx浓度;增大进料速率却导致NOx排放浓度的增加.当过剩空气系数(α)低于1.0时,NOx排放浓度随着α的增大急剧上升;大于1.1时,NOx排放浓度随α增加而减小.苯胺废液高温焚烧时添加氯化钠能降低NOx排放.     

组合型生态浮床对上覆水和沉积物之间氮磷的影响

在天鹅湖水体中构建以水生植物和陆生喜水植物为实验植物,浮法控制器、水循环增氧系统和造浪-输送系统为辅助设备的组合型生态浮床.组合型生态浮床运行期间改变了水体的理化环境,影响了上覆水-沉积物中氮磷形态的迁移转化,跟踪监测在组合型生态浮床影响下上覆水和沉积物TN、NH4+-N和TP含量的浓度变化规律,探讨了在组合型生态浮床作用下,DO、Eh、pH对上覆水和沉积物中营养盐的影响,以及上覆水和沉积物中氮磷之间以及和各环境因子之间的相互关系.结果表明,实验期间上覆水中TN、NH4+-N和TP的去除率分别达到61.92%、63.09%和80.0%.沉积物中TN和NH4+-N的去除率分别达到23.79%和37.04%,沉积物中TP含量上升了43.71%.组合型生态浮床对上覆水环境因子如DO、Eh、pH等产生不同程度的影响,处理区上覆水中DO和Eh均高于对照区,DO由原来的8.7～8.9 mg·L-1上升到9.3～10.4 mg·L-1,Eh由原来的163～178 mV上升到191～198 mV,通过提高上覆水中DO和Eh有效抑制沉积物磷的释放并促进沉积物对上覆水中磷的吸附.pH的波动性较小,维持在7.51～8.32之间,并未促进沉积物磷释放.上覆水中TN、TP和NH4+-N以及与沉积物中的TN、NH4+-N之间呈极显著正相关,与沉积物中的TP极显著负相关;pH与上覆水和沉积物中的TN、TP和NH4+-N都无相关性;上覆水中的DO与Eh显著正相关,与沉积物中的TP显著负相关.     

Pollutant emission characteristics of rice husk combustion in a vortexing fluidized bed incinerator

Rice husk with high volatile content was burned in a pilot scale vortexing fluidized bed incinerator. The fluidized bed incinerator was constructed of 6 mm stainless steel with 0.45 m in diameter and 5 m in height. The emission characteristics of CO, NO, and SO2 were studied. The effects of operating parameters, such as primary air flow rate, secondary air flow rate, and excess air ratio on the pollutant emissions were also investigated. The results show that a large proportion of combustion occurs at the bed surface and the freeboard zone. The SO2 concentration in the flue gas decreases with increasing excess air ratio, while the NOx concentration shows reverse trend. The flow rate of secondary air has a significant impact on the CO emission. For a fixed primary air flowrate, CO emission decreases with the secondary air flowrate. For a fixed excess air ratio, CO emission decreases with the ratio of secondary to primary air flow. The minimum CO emission of 72 ppm is attained at the operating condition of 40% excess air ratio and 0.6 partition air ratio. The NOx and SO2 concentrations in the flue gas at this condition are 159 and 36 ppm, which conform to the EPA regulation of Taiwan.